RS485 Component - Modbus RTU Interface

RS485

Path: src/RS485.cpp

Revision History: Initial documentation

The RS485 component provides a Modbus RTU interface for industrial communications. It acts as a gateway between Modbus TCP and Modbus RTU, managing serial communications with connected hardware devices and exposing them to the higher-level systems.

REQUIREMENTS

• Hardware:
  • RS485 transceiver (typically connected to a UART port)
  • GPIO pin for DE/RE (Data Enable/Receive Enable) control
  • UART pins (RXD1_PIN, TXD1_PIN)
• Software:
  • ModbusClientRTU library
  • ModbusRTU implementation
  • Configuration in config-modbus.h

FEATURES

• Manages communication with multiple Modbus RTU slave devices
• Bridges between Modbus TCP and Modbus RTU protocols
• Monitors and reports register changes from devices
• Provides error handling and reporting
• Supports device discovery and monitoring
• Dynamic registration of device capabilities with TCP server
• Periodic polling of RTU devices

DEPENDENCIES

• Component - Base component system
• ModbusRTU - Modbus RTU implementation
• ModbusTypes - Common Modbus data types
• RTUutils - Utilities for RTU communication
• RS485Devices - Device registration

BEHAVIOUR

TODOS

PERFORMANCE

• Consider optimizing polling frequency based on device importance or activity
• Implement batched read operations for devices with consecutive register addresses
• Add performance metrics tracking for RS485 bus utilization and response times

SECURITY

• Implement validation of received data to prevent buffer overflows
• Add authentication mechanisms for critical device communications
• Consider encryption for sensitive data transmission

COMPLIANCE

• Ensure full compliance with Modbus RTU specification
• Consider implementing Modbus exceptions handling according to standard
• Document protocol compatibility with various industrial equipment standards

RECOMMENDATIONS

• Create a configuration tool to easily manage device mappings
• Implement automatic baudrate detection for connected devices
• Add diagnostic features for bus monitoring and troubleshooting
• Consider implementing a fallback mechanism for unreliable connections

EXAMPLE

This example shows how to initialize and mount the RS485 component in a main application:

#ifdef ENABLE_RS485
  rs485 = new RS485(this); // 'this' is the owner component
  if (rs485) {
    components.push_back(rs485);
    Log.infoln(F("RS485 component initialized."));

    // Register RS485 as ModbusTCP data provider, if TCP is available
#ifdef ENABLE_MODBUS_TCP
    if (modbusTCP) {
      rs485->mb_tcp_register(modbusTCP);
    }
#endif
  } else {
    Log.errorln(F("RS485 initialization failed."));
  }
#endif

References